Safety; Operating Precautions - Shindaiwa 65001 Manuel D'utilisation

Safety

This machine operates at very high speeds and has the
potential to do serious damage if misused, abused or mis-
handled. To reduce the risk of injury, you must maintain
control at all times, and observe all safety precautions
during operation. Never permit a person without training
or instruction to operate this machine!

Operating Precautions

■
This Shindaiwa trimmer tool is
specifically designed for use on
the Shindaiwa Multipurpose Tool
Carrier. Installation and/or use on
any other model, brand or type
of power tool is not approved by
Shindaiwa. Attempts to use on
non-approved models can damage
the equipment and cause acci-
dents, serious injury or death.
■
Always make sure the Multipur-
pose Trimmer Tool is properly
installed and firmly tightened
before operation.
■
Never extend trimming line beyond
the length specified for your unit.
The Properly Equipped Operator
ALWAYS protect yourself from
hazards such as thorny brush
and flying debris by wearing
gloves and close fitting clothing
that covers arms and legs.
Never wear shorts. Don't wear
loose clothing or items such as
jewelry that could get caught
in machinery or underbrush.
Secure long hair so it is above
shoulder level.
Keep a proper
footing and do not
overreach—main-
tain your balance
at all times during
operation.
Wear sturdy footwear with
nonslip soles to provide good
footing. Steel-toed safety boots
are recommended. Never
operate unit bare-footed!
For specific maintenance and safety information about your
Multipurpose Tool Carrier, consult the owner's manual
provided with it. If it has been lost or misplaced, contact a
Shindaiwa dealer for a replacement.
WARNING!
■
Never use a cracked or warped
cutting attachment: replace it with
a serviceable one and make sure
it fits properly.
■
Before starting the engine, make
sure the cutting attachment is not
contacting anything.
■
Always stop the engine imme-
diately and check for damage if
you strike a foreign object or if the
machine becomes tangled. Do not
operate with broken or damaged
equipment.
■
Stop the machine immediately if
it suddenly begins to vibrate or
shake. Inspect for broken, miss-
ing or improperly installed parts or
attachments.
Always wear eye protection such as goggles or
safety glasses. Wear hearing protection devices
and a broad-brimmed hat or helmet.
NOTE:
■
Never transport the machine or set
it down with the engine running. An
engine that's running could be acci-
dentally accelerated causing the
cutting attachment to rotate
■
ALWAYS keep a Solid Stance.
Maintain footing and balance at all
times. Do not stand on slippery,
uneven or unstable surfaces. Do
not work in odd positions or on lad-
ders. Do not over reach.
Always operate with both
hands firmly gripping the unit.
Keep away from the rotating
trimmer line at all times, and
never lift a moving attachment
above waist-high.
Always make sure the ap-
propriate cutting attachment
shield is correctly installed
and in good condition.
3