Troubleshooting Guide - Shindaiwa 65001 Manuel D'utilisation

IMPORTANT! When the wear indicators located at the bottom of the Speed-Feed head are worn
smooth, replacement of the cover or the entire Speed-Feed head is required.
Wear Indicators

Troubleshooting Guide

Symptom
Excessive vibration.
Cutting attachment will not
move.
Cutting attachment
moves at engine idle.
ADDITIONAL PROBLEMS
Possible Cause
Warped or damaged attachment.
Loose gearcase.
Bent main shaft/worn or damaged bushings.
Shaft not installed in powerhead or gearcase.
Broken shaft.
Damaged gearcase.
Engine idle too high.
Broken clutch spring or worn clutch
spring boss.
Wear Indicators
Remedy
Inspect and replace attachment as
required.
Tighten gearcase securely.
Inspect and replace as necessary.
Inspect and reinstall as required.
Consult with an authorized Shindaiwa servicing
dealer.
Adjust idle. Check Specifi cations page for correct idle
speed.
Replace spring/shoes as required, check idle speed.
9