Bluetooth Pairing; Troubleshooting - Wagan Tech Power Dome NX 2 Manuel D'utilisation

Note: The Power Dome's USB Power Port can conveniently charge your audio or mobile device
while music is playing.

BLUETOOTH PAIRING

Pair your Bluetooth enabled phone or tablet to the Power Dome
1. Press the PWR (power) button to turn on the Power Dome radio.
2. Press the MODE button to change the input mode until you see "BT" on the LCD screen.
3. You will hear an elevating tone initiating the Bluetooth receiver and the "BT" text will flash
while in pairing mode.
4. Set your device (phone or tablet) to search for Bluetooth devices. Please refer to your
device's user manual for specific instructions.
5. After searching is complete, you should see "DN018BT" in the device list. Select this and
the Power Dome will automatically connect.
6. The Power Dome speakers will emit a chime indicating that a successful connection has
been made. The "BT" text on the display will change from flashing to solid once connected
to a device.
7. The Power Dome is ready to be used as a Bluetooth speaker.
8. The Power Dome Bluetooth setting is able to play music and receive phone calls. When a
phone call is received, press the "CH—/ " for two seconds to pick up the call. To hang up
the call, press the "CH—/ " again for two seconds. Restart the music on your device if it
does not restart automatically when the call has ended.
9. There is a small hole for the microphone that is visible near the radio on the Power Dome.

TROUBLESHOOTING

Problem
Air compressor shut-off.
Lack of power output.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
Cause
High temperature
protection.
Power Dome battery
voltage is below 10 volts.
Excessive current drawn
by appliance being
operated.
Inverter fuse blown.
©2016 Wagan Corporation. All Rights Reserved.
NX 2.
™
Solution
Allow the Power Dome cool for about 10 minutes.
Recharge the Power Dome immediately.
Reduce load to maximum wattage.
1. Turn off the device and inverter.
2. Disconnect device.
3. Turn the inverter on and let it run for a
minimum of 2 minutes.
4. Turn inverter off.
5. Quickly plug device into inverter.
6. Turn on both the inverter and the device.
Check and replace if necessary. Be sure
replacement fuse is the same type and rating.
17