Dc Output Socket; Usb Power Port - Wagan Tech Power Dome NX 2 Manuel D'utilisation

Power Dome
™
4. Connect the electrical plug of your device/appliance to either of the two AC outlets.
5. Set the Inverter Switch to the "|" position.
6. Observe the Inverter Power Indicator. If the LED remains green, proceed to plugging in and
turning on the second device/appliance.
• If the power indicator remains green, then both devices/appliances are operating
properly.
• If the power indicator is no longer lit, reduce the AC load. If the inverter still does not
operate after load is reduced, refer to the troubleshooting table at the end of this User's
Manual.After use, remove the device/appliance plug(s), close the dust cover(s), and turn
the Inverter Switch off.
7. Recharge the Power Dome as soon as it is convenient.

DC OUTPUT SOCKET

The DC accessory socket can power a DC load up to 11 Amps. Overloading the socket will result
in tripping the self-resetting circuit breaker. Removing the overload automatically restores power
to the DC socket. For proper and safe operation of the 12 Volt DC power accessory socket, do
not place anything in them except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Power Dome's maximum wattage.
2. Remove the dust cover from the DC socket.
3. Insert the 12V DC plug of your device/appliance into the Power Dome's DC socket.
4. Set the DC/USB Switch to the "I" position.
5. Check for the indicator to be lit.
6. Operate your device/appliance as usual.
7. After use, remove the device/appliance's plug, close the dust cover, and turn the DC/USB
Switch off.
8. Recharge the Power Dome as soon as convenient.

USB POWER PORT

1. Remove the dust cover.
2. Connect a user-supplied USB cable to the USB power port on the Power Dome.
3. Set the DC/USB Switch to "I" position.
4. Check for the indicator to be lit.
5. Operate your mobile device as usual.
6. After use, disconnect the USB cable and turn the DC/USB Switch off.
7. Replace the dust cover.
8. Recharge the Power Dome as soon as convenient.
14
NX 2 by Wagan Tech
www.wagan.com
®