Wagan Tech Power Dome NX 2 Manuel D'utilisation page 18

Power Dome
™
Problem
Loud buzzing sound.
Inverter Power Indicator
is not lit.
Inverter automatically
shuts down.
Television/power
tool will not start.
Television Interference.
Static/noise interference
in audio system.
18
NX 2 by Wagan Tech
Cause
Battery charge level is
too low.
Excessive voltage drop.
Inverter is overloaded.
AC overload.
Required wattage
exceeds Power Dome
peak surge for start-up.
Picture breaking up
(static).
Sound system has weak
alternating current
shielding.
www.wagan.com
®
Solution
1. Disconnect all appliances.
2. Turn inverter off.
3. Charge Power Dome fully. (See charging
section for more details.)
Check internal battery status and recharge if
voltage drops below 10 volts.
Reduce load to maximum wattage.
Unplug and power off to restart then reduce AC
load to maximum wattage.
Toggle the Inverter Switch on and off in quick
succession for 5 times. If the device does not
start, the device is not compatible with this type
of inverter.
Place the Power Dome as far as possible from
the TV, antenna, and coaxial cable.
TV station may be out of range.
Do not use the Power Dome's inverter with low-
quality audio AC filtering system.
Replace audio system with high quality noise
filtering.