Turning On And Tuning The Radio; Adjusting The Volume; 5Mm Audio Input - Wagan Tech Power Dome NX 2 Manuel D'utilisation

Voltmeter

Table des Matières

Les langues disponibles

Power Dome

™

Power

Microphone

Mode

Turning On and Tuning the Radio

1. Carefully raise and extend the antenna.

2. Press the PWR (power) button to turn the radio on. The current frequency is displayed in the

center and the "AM" or "FM" band is shown in the corner of the LCD screen.

3. Tap the MODE button to switch between AM and FM bands.

4. Tap the "CH+" and "CH−" buttons to adjust the station. Press and hold the buttons to

automatically scan stations.

5. When finished, press and hold the PWR (power) button to turn off the radio. Carefully retract

the antenna and return it to the lowered position.

1. With the radio turned on, tap the "VOL+" or "VOL−" buttons to adjust the volume. Press and

hold the buttons to adjust the volume quickly. The radio can be adjusted up to 16 levels.

2. When using an external audio device in the Audio Input Jack, the volume will be controlled by

the external device.

3�5MM AUDIO INPUT

1. Turn the radio on.

2. Push the MODE button until you see "AU" on the LCD screen.

3. Insert a user-supplied 3.5mm audio cable into the auxiliary input jack.

4. Insert the opposite end of the cable into a compatible audio device.

5. Turn on the audio device and set it to output sound. The sound should be audible from the

Power Dome speakers.

NX 2 by Wagan Tech

CH +

Auxiliary Input

www.wagan.com

LCD screen

VOL +

VOL −

CH −/

Table des Matières