Remote Control - Waeco mobitronic RV-RMM-70 Instructions De Montage

Operating elements
POWER, Contactor/circuit breaker (see F 1.1).
Contactor/circuit breaker of the monitor has no function (see F 1.2).
no function (see F 1.3).
If the remote control does not work, press once the MONITORkey
(see F 1.3) and continue then as usual.
VOL UP/DOWN, Volume control, 2 buttons for loud or soft (see F 1.4).
PICTURE (see F 1.5), Button for the image- and function setting (same function as
key MODE at the monitor, see D 1.6).
Calls up the menu as follows:
Press the key PICTURE (see F 1.5) on the remote control or MODE (see D 1.6) on the
monitor. Graphics appear for the function setting.
Change the values of following graphics with the keys VOL UP/DOWN
(see F 1.4) (see also representation of the screen graphics on the next page)
Contrast (CONTRAST) k Brightness (BRIGHTNESS) k Color (COLOR) k Color value (TINT)
(only with NTSC-video format) k blue screen with missing video signal, On/Off (BLUE
SCREEN) k Automatic switching-on as soon as voltage supply is present, On/Off
(POWER DIRECT) k Video format PAL/NTSC (COLOR SYSTEM)
k normal-/mirror image (MIRROR MODE).
k Image format selection (MODE SELECTOR) (see F 1.5 and D 1.6):
1 FULL = 16:9
2 NORMAL = 4:3
3 CINEMA = 16:9 enlarged
4 WIDE = 16:9 reduced in size
MUTE switches off the loudspeaker (see F 1.6).
AV is used for switching the video inputs (see F 1.7).
SET direct selection of the image formats (see F 1.8).
Battery change
Push down the cover of the battery compartment (see F 2).
Insert the batteries (2 x 1.5 V, type AAA). Take care that there is correct polarity
(see F 3).
Close the compartment again (see F 4).

Remote control

28