using the remote control unit
1. To activate the remote control unit,
press the touch pad as indicated in
the diagram. Four activation lights will
light up.
2. Press the forward arrow briefly. The
robot will start moving in a forward
direction.
To stop the forward movement, briefly
press and release the forward arrow.
3. Press the backward arrow briefly. The
robot will start moving in a backward
direction.
To stop the reverse movement, briefly
press and release the backward arrow.
on-the-spot turns
On-the-spot turns can be carried out while the robot is in motion or executed when the robot is
stationary.
4. To turn the robot clockwise, press and hold down the right arrow. The robot will turn-on-the spot.
Release the button to stop the robot from turning.
5. To turn the robot counter-clockwise, press and hold down the left arrow.
Release the button to stop the robot from turning.
6. To deactivate the remote control unit, press and hold down the touch pad. The activation lights
will switch off.
The robot reverts to its programmed direction mode of cleaning after the manual correction.
i
The remote control unit deactivates automatically after approximately 3 minutes and the
indicator lights switch off.
maintaining the remote control unit
The remote control unit is powered by 2 AAA batteries. It is splash-proof and should not be immersed
in water.
To replace the batteries, remove the 4 back-cover securing screws and replace all the batteries with
new battery cells.
14
-8151450_WAVE300XL_BOOK.indb 14
figure 16: The remote control unit
Forward
On-the-spot
turning
Backwards
Touch pad
On/Off switch
Wave XL
|
User Instructions
1/27/14 2:48 PM