assembly instructions
Refer to Figure 1
1. Attach the Caddy handle to the Caddy base and fasten with the 4 screws and 4 nuts provided.
2. Attach the cable roller to its place, and fasten with 2 screws. Note the location of the connection
cable between power supply and cable roller.
3. Place the Dolphin Wave robot on the Caddy in front of the power supply as shown in Figure 1.
4. Connect the MMI communication's cable to the power supply unit.
5. Connect the connection cable between power supply and cable roller.
Cable roller
Floating cable
Floating cable
handle
Impeller cover
Caddy
Remote control unit
Cable roller
handle
4
-8151450_WAVE300XL_BOOK.indb 4
MMI
MMI communications cable
Roller inner connection
Connection cable between
power supply and cable roller
AC cable holder
Power supply
Main power supply Cable
figure 1: The Dolphin Wave
Wave XL
|
User Instructions
1/27/14 2:48 PM