Troubleshooting - Maytronics Wave 300 XL Instructions Pour L'utilisateur

12. TroubLeSHooTinG

How to save a log file to USB memory stick (in case required by technician):
From the main Wave screen, press on the green buttons in sequence – 'right-left-right-left' and follow
the further instructions.
Error message
Imp over load
Imp over load
Imp under load
Drive over load
Drive over load
Drive under
load
DC input
Robot is stuck
on wall
Out of water
Robot is stuck
Navigation
System
Wave XL | User Instructions
-8151450_WAVE300XL_BOOK.indb 15
Check possible cause
Is there dirt or other foreign
matter in the impeller?
Does the problem reoccur
every operation?
Does the problem
reoccur every operation?
Is there any interfering dirt in
the driving belts, brushes, or
drive axles?
Does the problem reoccur on
every operation?
Does the problem
reoccur on every operation?
Is there an electrical
short, partial or complete
disconnection?
Is there a visible rupture in the
floating cable?
Has the robot stopped in
a vertical position of more
than 70º?
Has the robot stuck on an
obstacle?
Was the robot operated out
of the water for an extended
time?
Has the robot stopped on an
obstacle?
Is there an obstruction in the
water channel or in the robot's
driving belts?
Does the problem reoccur
every operation?
Action to take
Unscrew the bolt that secures the protective
cover of the impeller. Turn it counter-
clockwise slightly until it is released.
Remove any dirt from around the impeller.
Replace the protective cover.
Contact Maytronics dealer.
Contact Maytronics dealer.
Remove any dirt or foreign bodies that might
have become entangled with the driving
belts, brushes, or drive axles.
Contact Maytronics dealer.
Contact Maytronics dealer.
Contact Maytronics dealer.
Move the robot from its position and remove
the obstacle. Reactivate.
If this reoccurs, contact Maytronics dealer.
Check that the impeller is in order and that its
blades are not broken.
Reactivate. If this re-occurs, contact
Maytronics dealer.
Move the robot from its position and remove
the obstacle. Reactivate.
If this reoccurs, contact Maytronics dealer.
Contact Maytronics dealer.
15
1/27/14 2:48 PM