Starting Cleaning Operations - Maytronics Wave 300 XL Instructions Pour L'utilisateur

Masquer les pouces Voir aussi pour Wave 300 XL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11. After setting the Scan Mode , from the
Pool Profile screen, scroll down to the
next screen (Figure 15).
12. Press Select to enter Delay Time.
Setting a Delay Time allows you to delay
the start of cleaning operations by a time
factor selected from the MMI screen.
13. Line Spacing- this parameter is used in
order to optimize scanning.
Choose Fine / Medium / Coarse to set the
distance between the lines.
14. Reset Pool Profile- Allows you to delete all
current pool profile parameters.
( Pool Length, Cycle Time, Scan Mode,
Delay time ...)
During parameter setting operations:
TiP
• Press back to return to the previous screen.
• Press Home on the console, to return to the Wave screen.

Starting Cleaning operations

Once all the customized settings have been configured, you can proceed to a cleaning session:
1. Prepare the Dolphin Wave for operation and immersion into the pool.
2. On the MMI press PooL. The robot starts moving towards the pool, enters the pool and
positioning itself on the pool floor.
3. Wait for the WAVE screen to appear.
4. In every activation of the robot, it will straighten itself vertically to the wall of the starting point; the
robot will start moving backwards to straighten itself and then will continue in straight lines.
5. Press Start. The robot will start its cleaning operation.
If a Delay Time has been set (see Configuring the Dolphin Wave, above), the countdown commences
and the time remaining before automatic cleaning starts is displayed on the screen.
If no delay time is specified, the robot begins cleaning immediately.
Once cleaning operations have started, the MMI screen displays the countdown time as in Figure 4.
To override the delay time to start cleaning immediately, choose start from the delay
TiP
countdown screen. The robot will begin working immediately.
TiP
If the screensaver is displayed, press PooL and then Home to unlock the MMI.
12
-8151450_WAVE300XL_BOOK.indb 12
Pool A Profile
Delay Time
Line Spacing
Reset Pool A profile
Select
figure 15: Pool a menu: Second screen
Wave XL
|
0 h
Medium
Back
User Instructions
1/27/14 2:48 PM

Publicité

Table des Matières
loading

Table des Matières