Shut Down; Dc Operation Guidelines; Refrigerator Care Checklist - Norcold N8DC Série Manuel D'utilisation

- Touch the CABINET COMPARTMENT [6] button to set the compartment temperature setting.
-Using the + [4] or – [2] buttons adjust the temperature setting.
- The mode [3] will display the temperature setting
- 0 is off
- 1 is the warmest setting
- 5 is the coldest setting
- Press any button to return the control to activate mode, the mode [3] will illuminate. The display will return to standby mode after 5
seconds.
-Touch the NIGHT MODE [7] button to set the refrigerator to night mode. The blue indicator will illuminate.
- Night mode will turn off automatically after eight hours or if you push the night mode button again to turn the blue indicator light off.
- This 8 hour night mode setting can be changed by pressing the night mode button for 3 seconds. After the 3 seconds, the default 8
hours will be shown in the display . To change this setting, press the "+" or "-", then press night mode button to make the setting go into
effect.
-The new setting is archived in the memory until it is changed.

Shut down:

- To shut down the refrigerator, touch and hold the ON/OFF button [1] for 5 seconds and release.
- Once the refrigerator is turned OFF there is a 5 minute wait cycle before the refrigerator can be turned ON. The refrigerator will not
turn on again until the 5 minute wait is up.
Do not operate the refrigerator when the ambient temperature is above 140°F operation above recommend-
!
CAUTION ed ambient temperatures can cause permanent damage to the compressor. Operation when the ambient
temperature is hgher that 110°F can reult in poor colling performance.

DC Operation Guidelines

Refer to the installation Manual for DC Operation requirements and guidelines.

Refrigerator Care Checklist

Your refrigerator will give you years of trouble free service if you do these simple checks every three to six months:
- Keep the food compartment and the freezer clean. See "Cleaning".
- Defrost the refrigerator as necessary. See "Defrosting".
- Make sure the door seals correctly. See "Door Sealing".
- Be aware of any cooling changes that are not because of weather, loading, or thermostat changes. If changes occur, contact your
dealer or an authorized Norcold Service Center.
- Make sure the air flow in the lower intake vent, through the refrigerator condenser and coils and out the upper exhaust vent is not
blocked or decreased.
:
Owner's Manual 7