HP Neverstop Laser 1000 Série Guide De Référence page 4

Problem
The Wireless light is
glowing steady amber.
The Wireless light is
glowing steady blue, but you
cannot print wirelessly.
The Wi-Fi Signal Strength
indicator on the control panel
shows only one or two dots.
Set up a wireless connection using Wi-Fi Protected Setup (WPS)
1. Press the WPS button
2. Within two minutes, press and hold the Wireless button
3. Wait about two minutes until the Wireless light
connection is established, and then continue software installation.
If the printer Wireless light
an error has occurred. Press the Cancel button , and then repeat the above steps to set up the connection.
Cause/Solution
The wireless connection is not established. Try the following solutions in order
until the problem is resolved:
1. Verify that the printer is within the range (30 m or 100 ft) of the wireless
network router.
2. If you are using a USB cable to temporarily connect the printer and
computer during set up, do not connect the USB cable until the software
prompts you to do so. If you connected the cable before being prompted,
unplug the cable and then reset the wireless signal as directed in the next
step.
3. Restore the wireless network settings:
a. Remove the USB cable from the printer.
b. On the printer, press and hold the Wireless button
button at the same time for 3 seconds.
c. Release the buttons. When the Wireless light
continue the installation.
4. Restart the printer and the router and then continue software installation.
5. Uninstall and reinstall the HP printer software.
6. Use Wi-Fi Protected Setup (WPS) if your router supports it. See "Set up a
wireless connection using Wi-Fi Protected Setup (WPS)" on page 3.
Alternately, you can set up a Wi-Fi Direct connection to use your printer
without a wireless router. For help, see "Set up a Wi-Fi Direct connection" on
page 4.
The printer driver might not be installed. Try installing or reinstalling the
printer driver, and then try printing again.
If you still can't print wirelessly, the printer and your computer or device might
be connected to different networks. Try the following:
1. Check the network that the computer is connected to.
2. Check the printer's network name (SSID) info on the Wireless Network Test
Report. To print the report, press and hold the Wi-Fi button
Resume button
3. Resolve any connection issues, and then continue software installation.
The wireless signal is weak. Try moving the printer. Make sure there are no
large obstacles between the printer and the network router that could be
blocking the signal. Also, remove any electronic devices near the printer that
could be interfering with the wireless signal.
on your router.
turns amber and the Cancel light starts blinking, WPS setup mode has timed out or
at the same time for 3 seconds.
on the printer control panel for 3-5 seconds.
stops blinking and glows steady blue, indicating the
and the Cancel
starts blinking blue,
and the
3