Technical Specifications - Storch FloorCheck Mode D'emploi

A comparative measurement with the measuring needles of the HPM3000+ unit can
help to better interpret the measurement result. If the measurement result obtained with
the HPM3000+ unit is significantly lower than that obtained with the FloorCheck sen-
sor, it means the surface is drier than the core of the measured material. Compare the
measurements obtained with the FloorCheck sensor with the maximum allowable moi-
sture levels specified in the technical data sheets provided by the flooring manufacturer.
If the values determined with the FloorCheck sensor are higher, then the screed must dry
until it falls below the relevant values. Or the user must officially notify the client of this
concern prior to subsequent treatment.

6. Technical specifications

STORCH FloorCheck
Device type:
Measurement of water content: In weight percentages in relation to the dry mass
Display resolution:
Measuring tolerance:
Measuring depth:
Operating temperature:
Permissible humidity:
Measuring method:
Accessory sensor for the non-destructive detection of
material moisture (screed moisture content) in connec-
tion with the Storch HPM3000+ measuring instru-
ment.
Additionally, the corresponding CM% values are
displayed.
0.1%
+/- 0.2%
max. 10 cm
4 to 50°C
5 to 90% RH non-condensing
Capacitive
38