Programming; Programming Pre-Set Buttons; Resetting Pre-Set Buttons - Vitamix The Quiet One Mode D'emploi

P R O G R A M M I N G
The Quiet One® is pre-programmed with an Advance® program which is optimized
for the Advance® container. The program can be customized by using the control
panel, or a programming chip or programmer software kit available from Vitamix®.
Call your distributor or customer service for more information.

Programming Pre-Set Buttons

1. Access the 34 stored programs by activating the power switch located on the back
of the motor base while depressing the High Pulse button. The display will say
"BUTTON SET UP"
2. Press the Speed or buttons to scroll through the "Recipe" numbers until you
reach the one you want. (For a description of each recipe, see page 12.)
3. Press the Pre-Set button that you want to program for the recipe selected.
For Example: If you wanted to program
BUTTON SET UP
button 1 with recipe #17:
RECIPE 1
1. After accessing the stored programs as described in step 1,
BUTTON SET UP
the display window will say "BUTTON SETUP."
RECIPE 17
2. Press the Speed
BUTTON SET UP
RECIPE 17-------->1
3. Press the 1 button to apply Recipe 17.
4. Either continue programming the other five buttons or
READY
press the High Pulse button to exit and continue blending.
Programming your Machine
with a Custom Chip
1. Turn on the machine.
2. Remove the container and rotate the machine to the rear so
that you can see the programming port.
3. With the rear of the machine facing towards you, insert
the custom programmed chip (with the words, "THIS SIDE
FACING TO THE FRONT OF THE MACHINE" toward the left)
into the port located on the right hand side of the machine
opposite the On/Off switch. Push gently until chip engages
into the port. The display window will read "NEW MODULE."
4. Within 10 seconds, the six Pre-Set buttons will be
re-programmed and the display window will read
"Saved" then "Ready."
5. Remove the programming chip, return it to the original
Custom Programmed Chip
package and store in a safe, easily accessible spot.
6. Press one of the six Pre-Set buttons to reveal, in the display
window, the name of the program/drink.
10
button until the screen displays "Recipe 17."
Resetting the Pre-Set Buttons
to the original factory settings
1. Access the Owner Controls by activating the power switch located on
the back of the motor base while depressing button 2.
2. Once the unit powers up, it will cycle through three screens then stop on the motor
status screen. Depress button 2 again, within 12 seconds, to scroll through the
menu settings.
3. Scroll using button 2. The screen will display "1 TO OVERWRITE CURRENT
PROGRAM". Depress button 1 to reset to the original factory settings.
IMPORTANT NOTES!
Programming Chip: If the above programming steps are taken and the custom
programming does not appear with the first blend cycle, turn the chip 180˚
(side-to-side) and try again.
11