Assembling.the.blower - Shindaiwa EB2510 Manuel D'utilisation

Assembling the Blower
Push the blower tube
over the discharge port
and locking pin
Blower Tube
Locking Pin
1
Rotate clockwise to lock
2
Place.the.blower.upright.on.the.ground.or.
on.a.sturdy.work.surface.
1.. Grasp.the.blower.tube.as.shown,.and.
push.the.tube.over.the.blower.discharge.
port.and.locking.pins.
2.. Lock.the.blower.tube.to.the.blower.
discharge.port.by.rotating.the.tube.as.
shown.until.the.locking.pin.snaps.into.
place.
6
Blower Tube
EB2510_132
Locking Pin
3
Rotate clockwise to lock
Mark
"THIS SIDE UP"
must face up
4
EB2510_133
3.. Grasp.the.nozzle.with.the.mark."THIS.
SIDE.UP".positioned.as.shown,.and.
then.push.the.nozzle.over.the.straight.
tube.and.locking.pins.
4.. Lock.the.nozzle.to.the.straight.tube.by.
rotating.the.nozzle.as.shown.
EB2510_134
5
5.. To.detach.the.blower.tube,.push.the.
locking.pin.in.as.shown.and.rotate.tube.
counter-clockwise..The.hex.wrench.can.
be.used.
Push the nozzle
over the blower
tube and locking
pin
Nozzle
EB2510_135
IMPORTANT!
Blower tube installation affects both blow-
er balance and performance! The tube
and nozzle are correctly installed when
the mark "THIS SIDE UP" is visible to the
operator during normal operation.
WARNING!
Danger from rotating impeller!
Stop the engine before installing or
removing the blower tubes! Never
perform any maintenance or assembly
procedures on this unit while the
engine is running!