Lubrication - BH FITNESS S2TiB Manuel Du Propriétaire

MAINTENANCE
To adjust the running belt, stop the treadmill,
then use the 6mm hex wrench and adjust the hex
screw located in the rear end cap. If the running
belt is moving towards the left side, tighten
the left hex screw with a 1/4 turn (clockwise);
if the running belt is moving towards the right
side, tighten the right hex screw with a 1/4 turn
(clockwise); Turn the treadmill on after it has
been adjusted. If you find that the belt has not
moved to the proper position, please repeat the
steps above. Don't use the treadmill until the
running belt returns to the center position.
The position of running belt might not stay
precisely in the center, it can and will shift
slightly towards the left and right sides, however,
you do not need to adjust the belt if it is not
rubbing against the side rails.
If the user feels the belt slipping, this may mean
that the belt has loosened. To tighten the belt,
turn the left and right adjustment key screws
clockwise in 1/4 turn increments until there is
no slipping.

LUBRICATION

a.) Lubricate the treadmill every 5 months if the machine is used under 3 hours per week.
b.) Lubricate the treadmill every 2 months if the machine is used between 4-7 hours per week.
c.) Lubricate the treadmill every month if the machine is used over 7 hours per week.
Note: The running belt should be lubricated with Silicone Oil.
Do not over lubricate the treadmill. Proper lubrication is significant to the durability of the
treadmill.
18