Bertazzoni REF31BMFIX Mode D'emploi De L'installateur page 14

5. After connecting the water supply, water
filter, and the
connecting system layout shows below.
If you choose to use without the water filter.
4. Connect the
1/4"tube(assembled)
refrigerator by a connector.
1) Fully insert the other head of the
into the connector.
1/4"tube(assembled)
2) Fully insert the water line of the
refrigerator (at the right of the compressor
room) into the connector.
3) Insert two clips in the install pack as
shown below, and then confirm that each
clip holds the water line firmly.
14
refrigerator, water
1/4"tube(assembled)
with
Follow up inspections apply to both units
with and without filters.
Note:
It is recommended to employ a qualified
person to install the water system.
If you have to repair or disassemble the
water line, cut off the ends of water line
(1/4") to make sure you get a snug,
leak-free connection.
 It is suggested to change the water filter
every 6 months to ensure the best possible
water quality. Filters may be purchased at
Encompass Parts (https://
encompass.com/) under the SKU Z320380.
After installing, check the installation
thoroughly for leaks. For filter replacement
instructions please see pg. 17.
Warning!
 After turning on the shutoff valve, make
sure that there is no leakage at all
connection points of the water lines.
If there is a leakage, turn off the shutoff
valve immediately and
connector or make the water lines fully
inserted into the connector.
 After powering on the refrigerator, let the
ice maker make ice for one to two days,
then throw out the first one or two buckets
of ice to make sure that all impurities have
been removed from the water lines.
 Do not pull hard on the water lines, it may
damage the water system.
 The water line should not be pressed by
heavy things and should not bend too
much.
IMPORTANT:
The warranty does not cover any parts,
labor, or damage to property caused by
improper installation, use, maintenance,
repair or service.
tighten the