Siemens SITRANS LR250 Guide Rapide page 24

Quick Start Wizard via AMS Device Manager
Notes:
• Complete the steps in order. Click on Apply after revising parameters in each step, or
CANCEL to exit step without saving changes. (Note: Apply will write changes to the
device. OK will write changes to the device and exit to the Device Connection View.
CANCEL will exit to the Device Connection View without applying changes.)
• Do not use the Quick Start Wizard to modify individual parameters: see instead the AMS
chapter in the full LR250 FF Operating Instructions manual. (Perform customization only
after the Quick Start has been completed.)
• Values set using the Quick Start Wizard via AMS Device Manager are saved and recalled
each time it is initiated (unlike the Quick Start Wizard initiated via the handheld
programmer).
• To run the Quick Start Wizard for this device, the RESOURCE block must first be set to Out
of Service (OOS) mode, before any configuration changes (changes to parameters
affecting block output) can be written. (Setting RESOURCE block to OOS also sets LTB to
OOS.)
• After completing steps 1-4, review all settings in
further changes are required.
• After completing the Quick Start Wizard from AMS, you must manually place the
RESOURCE block in Automatic mode.
Launch AMS Device Manager and double-click the device icon from the Device Connection
View to open the startup screen. Navigate to Configure/Setup > Resource Block > Wizards >
Quick Start, and click on Step 1 - Identification.
Modify parameters as required, and click on Apply to save settings in each Step 1 to 4. Review
all parameter settings in Step 5 - Summary. Return to individual steps if further changes are
necessary. The Quick Start Wizard is now complete.
7ML19985XN82 SITRANS LR250 (FF) – QUICK START MANUAL
Step 5 - Summary
. Return to steps1-4 if
Page EN-23