MRA 4025066147588 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Scheibe
1 Holding plate 1
1 Holding plate 2
8 Screws M5 x 16
8 Plastic washers
8 Rubber nuts
2 Screws M5 x 10
2 Nuts M5 black
1 Edge protection strip, sleeves
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Remove the original screws and the original screen (P1). Remove the screws and parking light (P2).
3. Remove the screws on the speedometer bracket (P3).
4. Now unscrew the parking light bracket screws and remove it. Carefully pull the cable by around 2cm
from the surrounded part (P3).
5. Remove the grommets from the bracket (P4).
6. Lift the speedometer or dash slightly and insert the holding plate 1 underneath the speedometer
bracket (P5). ! Warning ! The sleeves in the speedometer bracket may fall out!
7. Screw the speedometer bracket screws and washers back in. Screw the M5x10 screws included
together with the original washers (P6) into the other two empty holes.
8. Place four of the rubber nuts into the holes, and the grommets from the parking light bracket into
the two large holes (P6).
9. Position the parking light and fasten it with the original screws, bushings, washers and black nuts
(P7).
10. Position bracket 2 and fasten it with using the screws and plastic washers.
11. Insert the rubber washers into the holes (P8).
12. Now mount the original screen again.
13. Position the racing screen and fasten it with the screws and plastic washers (P9).
14. If desired, fit the protective edge strip on the rear exposed part of the screen, starting where the
fairing overlaps and continuing to the opposite side. Any remaining strip should be cut away.
15. It is also possible to push the clamping sleeves over the ends of the protective edge strip and lightly
compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Z1000 2014-
Article No..
--- Allen key 3 & 4mm
Wrench 8mm
10989
Socket wrench 10mm
10990
10554
10635
10629
10995
10557
---
3
Required tools