Mounting On A Table; Wall Installation - Bresser WoW200 Mode D'emploi

removed out of the Main Unit, the icon

MOUNTING ON A TABLE

The receiving unit is equipped with a base which allows you to mount it
on an even surface.

WALL INSTALLATION

1. Before mounting the device on a wall, make sure that the location of-
fers the receiving unit optimal reception from the external sensor.
2. Mount a screw in the desired location. Ensure that the screw can
hold the weight of the receiving unit. Leave a space of about 5 mm
between the head of the screw and the wall. Hang the receiving unit
on the screw. Make sure that the receiving unit is securely fastened
onto the head of the screw before you let it go.
SETTING UP THE REMOTE TEMP. AND RC CLOCK
a. Once batteries are in place for the remote unit, they will start transmit-
ting temperature and humidity readings at around 45 seconds inter-
vals. The main unit will also start searching for signals for about two
minutes once batteries are installed. 10 seconds upon successful
reception, the outdoors temperatures and humidity will be displayed.
The main unit will automatically update its readings at about 45-sec-
ond intervals.
b. If no signals are received, blanks "
Hold [ SEARCH ] for 2 seconds to enforce another search for
about 2 minutes. This is useful in synchronizing the transmission and
reception of the remote and main units.
c. When remote signal reception is finished, it will automatically synchro-
nize its current time and dated when brought within rang of the "DCF"
RF signal. Repeat this step whenever you find discrepancies between
the reading shown on the main unit and that on the remote unit.
MAXIMUM AND MINIMUM TEMPERATURE AND HUMIDITY
The maximum and minimum recorded indoor / outdoor temperature
will be shown on display.
" will be displayed.
25
GB/IE