Technical Specifications - ITW SIMCO ThunderION Notice D'utilisation

3. Technical specifications

Power supply
Supply voltage
Max. current consumption 0.7 A DC
Connection
Output
Output voltage
Short-circuit protection
Max. current from emitter
to earth
Emitter material
Environment
Operating environment
Ambient temperature
Cooling
Operating distance
Local functions
Frequency setting
Indication of pulse
frequency setting
[On] signalling
[Fault] signalling
Remote functions
Remote On/Off
Bar operating OK
Mechanical
Effective bar length
Dimensions (WxHxL)
Weight
Housing
Mounting material
* The power supply must be a Limited Power Supply or NEC Class 2 power supply.
The output of the power supply must be properly grounded! (See para. 4.4.1.)
An LPS certified power supply has a limited output power, as a result of which it
always generates a safe output voltage.
ThunderION_UM_9752160010_NL_D_GB_F_V2_2
21 – 27 V DC stabilized *
Hirschmann GO6WF connector
Max. 30 kV positive and negative
Output electronically protected at max. output current
<0.7 mA
Special alloy
Industrial
0 – 55°C
Convection
300 – 1000 mm
1...10 Hz in 1 Hz increments; can be adjusted using the
rotary switch behind the PG-7 stopper.
(Standard 5 Hz, position 4)
Flashing red and yellow LEDs during start-up of the bar
and after adjustment of the pulse frequency.
Yellow LED
- Red LED lights up in the case of an overload or
short circuit.
- Red LED flashes when a repeated or
continuous overload or short circuit has occurred.
Switching high voltage on and off
Control voltage specifications:
10 V DC, 10 mA min.
30 V DC, 25 mA max.
Indicates that the bar is operating correctly
(when high voltage is switched on).
Max. load: 30 V DC, 50 mA.
250 mm to 4000 mm
47 mm x 93 mm x total length (Eff. Length + 205 mm)
0.8 kg + 1.5 kg/m
Glass-fibre strengthened plastic
Brackets and connector
30