Turning The Display On And Off; Taking A Picture - Bushnell IMAGEVIEW 11-1210 Mode D'emploi

to check the camera aim and focus before taking a new photo. To turn the unit off, press and hold the
MODE button until the display goes out and the camera beeps 3 times. The camera will turn itself
off automatically to save batteries if it is left inactive for one minute. When connected to a PC for
downloading photos, the camera draws power from the USB port.

TURNING THE DISPLAY ON AND OFF

Press the Display button (right side of the large 4-way switch) to turn the display off. Turning the display
off when it is not needed will save power and extend the useful life of the batteries. To turn the display
back on, press Display again.

TAKING A PICTURE

With the camera turned on, press the SNAP button to take a new photo. For best results, hold the
ImageView steady using both hands. Lightly press down the SNAP button using the flat end of your
finger, then release it. Avoid "punching" the SNAP button rapidly with a fingertip, resulting in shaky
photos. You will hear two quick beeps to confirm a photo was taken, and briefly see a screen displaying
the remaining photo capacity (now one less), battery indicator, and resolution setting (1 or 3 stars).
REVIEWING AND DELETING STORED PICTURES
You may review previous images currently stored in the camera's memory by either scrolling through
them one at a time, or seeing a "slide show" which automatically displays and changes images. To see
individual images, just press the UP (most recent to oldest photo) or DOWN (oldest photo first)
buttons on the 4-way switch. If you see a photo you wish to delete, press SNAP. You will hear a rapid
2