Krups XP4000 Mode D'emploi Et Garantie page 8

XP 4000/4020/4030 as long as they are
E.S.E. standard pods.
illy  is a registered trademark of illy espresso of
the americas, inc.
Starbucks  is a registered trademark of the
Starbucks Coffee Company
2. s
team function
cappuccino and latte
The thumping noise which occurs while
steam is being produced comes from the
intermittent regulation of the pump and has
no effect on the proper working of the
appliance.
If you wish to make an espresso imme-
diately after using the steam function,
the appliance must first be allowed to cool
down in order to achieve the correct tem-
perature for preparing an espresso.
When you turn the selector to the O set-
•
ting, the appliance automatically cools
down, launching 3 pumping cycles. The
cold water pumped in this way cools down
the heating system. During the pumping
cycles, the excess steam contained in the
heating system is released along with hot
water into the drip tray. The release of
steam and the accompanying noise are
required for the appliance to cool down.
Caution: during and after use of the ma-
chine, the metallic parts of the cappuccino
accessory can become extremely hot.
. Using the Cappuccino accessory
The Cappuccino accessory makes it easy
to produce frothy milk for making cappuc-
cinos, lattes and hot chocolates.
It is best to use fresh, skim or low-fat milk
that is well chilled (kept in the refrigerator).
The container must also be cold (do not run
it under hot water before frothing the milk).
For heating thick liquids, please refer to the
section "Heating thick liquids (e.g. soup)"
We recommend that you clean the cap-
puccino accessory immediately after use
- please refer to section "Cleaning the
Machine".
Fill the water container with fresh, cold
•
water (1) (2) (3) and turn on the appliance
(4).
.
for preparing
Move the cappuccino accessory to the
•
exterior of the appliance.
Turn the dial to the
•
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Immerse the cappuccino accessory in
•
the milk to be heated (you can use a
preferably stainless steel container with a
capacity of about 0,5 litres).
Hold the container under the cappuccino
•
accessory in such a way that the tip is im-
mersed in the milk.
Turn the selector to the
•
Keep the container straight during this
operation. Do not allow the tip of the cap-
puccino accessory to touch the bottom of
the container because this could obstruct
the steam output.
Once you have obtained the desired
•
quantity of frothy milk, turn the selector to
setting (15) for the following clean-
the
ing operation in order to prevent the milk
from drying on the cappuccino accessory.
remove the container.
•
place a container with water under the
•
cappuccino accessory.
select the setting again (16) to remove
•
the milk residue.
turn the selector to the O setting.
•
Cappuccino accessory has to be cleaned
•
properly after each use with milk. Please
refer to the section below entitled «Clea-
ning the machine».
. Heating liquids
Fill the water container (1) (2) (3) and turn
•
on the appliance (4).
Move the cappuccino accessory to the
•
exterior of the appliance.
Turn the selector to the setting
•
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Immerse the cappuccino accessory in the
•
container holding the liquid to be heated.
Then turn the selector to the
•
(16) until the liquid is hot enough, then
setting (15).
setting (16).
(15) .
setting
11