Krups XP 2000 Mode D'emploi page 19

Coffee leaks around the filter
holder.
Pump is very noisy.
Water does not run through.
Water runs through too
quickly.
The espresso has no froth
(froth on coffee).
The milk is not very frothy.
Lots of water on the coffee
The filter holder is not
mounted correctly or has not
been tightened sufficiently.
There are coffee grounds on
the edge of the filter.
The brewing head gasket is
dirty.
The brewing head gasket is
defective.
ESE pod not positioned
correctly.
No water in the water tank.
Water tank incorrectly inserted. Press firmly down on the water
Coffee grounds too old or very Use fresh coffee.
dry and the pump cannot
produce pressure.
No water in the water tank.
Water tank incorrectly inserted. Press firmly down on the water
The filter is blocked or the
coffee grounds are too fine
Brewing head grid is
encrusted.
Appliance needs descaling.
Coffee grounds too coarse.
Quantity of ground coffee is
insufficient.
Coffee grounds too coarse.
Coffee grounds stale or too dry. Use fresh coffee.
Cappuccino accessory blocked.See paragraph "Maintenance".
Milk not fresh.
Milk not suitable.
Insufficient quantity of ground Increase the quantity of ground
coffee.
See paragraph "Preparing an
espresso".
Clean around the filter and the
gasket.
Clean the gasket with a damp
cloth.
Contact an approved Krups
service center.
Be sure that the paper edges are
inside the basket.
Fill the water tank.
tank.
Fill the water tank.
tank.
Clean the filter and the grid on
the head.See the paragraph
"Maintenance" and try a
coarser coffee.
Put the grid to soak in descaling
solution.
See paragraph "Maintenance".
See paragraph "Descaling".
Try a finer coffee.
Use the spoon provided to
measure out the coffee.
Try a finer ground coffee.
Use very fresh milk.
Try another brand of milk.
coffee.
20
KRUPS