Krups XP 2000 Mode D'emploi page 18

4
Espresso
• Place a container under the brewing head. Run through about 1/3 of the liquid
immediately, setting the selector to the position
9
• Stop the appliance by pressing button (N) (4) and leaving the position
engaged and wait for 10 – 15 minutes to allow the descaler to take effect.
4
Espresso
• Next, start the machine again by pressing button (N) (4) and allow the rest of the
liquid to run through.
4
Espresso
• Then rinse with two water tanks of fresh water, clean the brewing head and replace
the grid on the head of the appliance (Consult the "Cleaning the Machine" section).
Troubleshooting
P P r r o o b b l l e e m m s s
Espresso not hot enough.
Caffé
Espresso Caffé
9
Caffé
06
22 05
Caffé
P P r r o o b b a a b b l l e e c c a a u u s s e e s s
Cups, filter and filter holder
are cold.
(9).
Espresso Caffé
06
22 05
Preheat the accessories (cups,
filter, filter holder) .See paragraph
"Preparing an espresso".
(9)
06
22 05
C C o o r r r r e e c c t t i i v v e e a a c c t t i i o o n n s s
06
22
05
19
KRUPS