Important Safety Instructions - Euro-Pro 473 Directives D'installation

¡ ° ¡ ±

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical sewing machine, basic safety precautions should always be followed, including
the following.
Read all instructions before using this sewing machine.
This sewing machine is designed for household use.
DANGER-
A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine
from the electrical outlet immediately after using and before cleaning.
-To reduce the risk of burns, fire, electric shock or injury to persons...
Warning
Do not allow to be used as a toy. Attention is necessary when this sewing machine is used by
1.
or near children.
Use this sewing machine only for its intended use as described in this manual. Use only attachments
2.
recommended by the manufacturer as contained in this manual.
Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly,
3.
if it has been dropped or damaged, or dropped into water. Return the sewing machine to the nearest
authorized dealer or service center for examination, repair,electrical or mechanical adjustment.
4. Never operate the sewing machine with any air openings blocked. Keep ventilation openings from
the sewing machine and foot control free from the accumulation of lint, dust, and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol spray products are being used or where oxygen is being administered.
8. To disconnect, turn all controls to the off
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
11. Always use the proper needle plate. The wrong plate can cause the needle to break.
12. Do not use bent needles.
13. Do not pull or push fabric while stitching. It may deflect the needle, causing it to break.
14. Switch the sewing machine off
threading needle, changing needle, threading bobbin, or changing presser foot and the like.
15. Always unplug sewing machine from the electrical outlet when removing covers, lubricating,
o r when making any other user servicing adjustments mentioned in the instruction manual.
16. Always unplug before replacing lamp. Replace bulb with the same rated 15 watts.
TO REDUCE RISK OF ELECTRIC SHOCK:
O position, then remove plug from outlet. ¡±
O when making any adjustments in the needle area, such as
¡±
SAVE THESE INSTRUCTIONS
1
Rev. 05/04E