DISASSEMBLy OF BATCH BOWL PARTS
ALWAyS UNPLUG THE CORD BEFORE DISASSEMBLING.
• Turn the bowl cover clockwise until the safety interlock tab on the cover is disengaged and the tabs
are clear of the groove in the tower. The feed tube will be at a position between 7 o'clock and
9 o'clock. In this position you can lift the cover off the bowl.
• Remove the large food pusher and sleeve from the feed tube by pressing the release tab that says
"PRESS HERE". Remove the small pusher from the large pusher.
Disassembly when removing the S-blade
• Remove the work bowl from the unit by rotating clockwise to disengage the tabs on the bottom of
the bowl platform from the work bowl. When the bowl handle is on the left (about 7 o'clock), you
can gently lift the bowl straight up and out.
It is recommended that you remove the bowl from the motor base before you
remove the S-blade.
• To remove the blade, keep a slight downward pressure on the top of the center hub of the blade
while removing the bowl from the motor base. This will form a seal to prevent food particles from
spilling into the center tube of the bowl, and onto the motor base or the work surface. Then remove
the S-blade from the bowl. Handle the S-blade with caution; the blades are extremely sharp.
Disassembly when removing an accessory disc
• Do not remove the work bowl until the accessory disc is removed.
• To remove an accessory disc, place your fingers on the outer edge of two opposite sides of the disc
and lift. The disc should remove cleanly. To remove the detachable stem, hold the disc in one hand
with the stem facing away from your hand. Be careful not to scrape your hand on any sharp edges,
depress the release switch with your thumb and rotate counterclockwise (anticlockwise).
• Remove the work bowl from the unit by rotating clockwise to disengage the tabs on the bottom
of the bowl platform from the work bowl. When the bowl handle is on the left (about 7 o'clock),
you can gently lift the bowl straight up and out.
WFP7E/K
9