Troubleshooting - Waring Commercial WFP7E Manuel D'utilisation

This section describes potential problems and the correct solutions for them. Problems that cannot
be solved with the guidelines listed below should be referred to one of your local distributors for
assistance. A listing of authorized service agencies is supplied with each Waring food processor.
• Pull the plug and try plugging into another outlet.
• Turn lever to ON ( ).
• Make sure the bowl is properly positioned on the motor base, that the bowl or chute cover is on
properly, and that the safety interlock tab on the cover has properly engaged the safety interlock
switch.
• The unit may have overheated. Refer to Resetting Thermal Protection section (page 11).
• Turn unit OFF (
• Remove bowl attachment.
• Remove food being processed from inside the bowl.
• Allow unit to cool for 5 minutes.
• Reassemble unit, and run first with the bowl empty, then add food back into the bowl and try again.
• Bowl is overloaded – remove food being processed and reload using smaller quantities.
If unit does not operate after you have followed the above
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown if there are fuses on this circuit.
• Contact your local distributor.
• Turn unit off, unplug it, and call local factory-authorized service agency.
• Turn unit off, unplug, disassemble, check bowl and blade to see if they have been rubbing together.
• If bowl and blade are rubbing, call your local distributor.

TROUBLESHOOTING

Unit does not start when assembled correctly
Unit stops running during processing
) and unplug.
Unit will not come up to full speed
If unit starts to spark or smoke
If food processor makes grinding noise
15