Cleaning The Filters; Foam Filter - Beko VCM 7180 Manuel D'utilisation

4 Cleaning and care

4.4 Cleaning the filters

Replace your filters at regular intervals according
to the frequency of use. It is recommended that
you replace the filters every 6 months for average
use.
While you empty the dust accumulated in the
dust container to clean the container, you need to
clean the motor protection filter, the foam filter
and HEPA filter as well.
A
WARNING: Do not use appliances
producing hot air such as hair dryer
or heater to dry the filters.
WARNING: Do not install the
filters without completely drying
A
them; otherwise, smell of moisture
may occur during use, water can
leak from the back of the appliance
or the filters may get damaged.
A
WARNING: Attach the filters into
their places after they have dried.
10 / EN
4.4.1 Motor protection filter (MIF)
This filter is located on the dust container.
1. Press the dust container removal button (2) and
remove the dust container (5).
2. Press the opening button for the motor
protection filter (MIF) housing (8).
3. Remove the motor protection filter by pulling it.
4. After shaking if off, wash it under running
water, wring it out gently and leave it to dry (for
24 hours minimum).

4.4.2 Foam filter

1. Push down the rear cover opening latch to open
the cover.
2. Remove the foam filter behind the cover and
wash it.
3. After shaking if off, wash it under running
water, wring it out gently and leave it to dry (for
24 hours minimum).
Vacuum Cleaner / User Manual
Foam filter