Unit Description; Initial Use - Beurer TL 50 Mode D'emploi

Lampe de luminothérapie
Masquer les pouces Voir aussi pour TL 50:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
General notes
Important
• If you are taking medication such as pain relievers, antihypertensives or antidepressants, consult your
doctor before using the daylight therapy lamp.
• People with retinal diseases as well as diabetics need to be examined by an ophthalmologist before be-
ginning to use the daylight therapy lamp.
• Please do not use if you have an eye disease such as cataracts, glaucoma, diseases of the optic nerve in
general and inflammation of the vitreous humour.
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• The lamp tubes are excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. ON/OFF button
4. Mains part connection

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 15 cm and
35 cm between the user and the device. The lamp is most effective at this distance.
Mains connection
• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
part described here.
• Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy
lamp. The mains part must only be connected to the mains voltage that is specified on the type plate.
• After using the daylight therapy lamp, unplug the mains part from the mains socket first and then discon-
nect it from the daylight therapy lamp.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
1
10
3
2
4

Publicité

Table des Matières
loading

Table des Matières