INTERNAL BLOWER PREPARATION
1. Position internal blower inside hood body so
3. Position capacitor box inside hood body and
hardware.
5. Connect 9 pin molex connector from internal
motor to 9 pin molex connector from capacitor
box cable. Secure cable to hood interior with zip
tie and zip tie holder.
hardware.
4. Secure ground wire from capacitor box to
ground wire rivet nut next to capacitor box.
6. Connect 6 pin molex connector from control
board box to 6 pin molex connector from
capacitor box cable. Secure cable to hood
interior with zip tie and zip tie holder.
10
www.zephyronline.com