Zephyr Okeanito Guide D'utilisation, D'entretien Et D'installation page 19

TROUBLESHOOTING PROCEDURES FOR OKEANITO
Issue Cause
After installation, 1. The power source is not turned ON.
the unit doesn't
is not connecting properly.
3. The switch board and control board wirings are
disconnected.
4. The switch board or control board is defective.
1. Wire harness from external or internal blower
blower is not might be disconnected.
turning.
3. The blower is defective, possibly seized.
4. The thermally protected system detects if the
blower is too hot to operate and shuts the blower
down.
5. Damaged capacitor.
The unit is 1. The blower is not secure in place.
vibrating.
3. The hood is not secured in place.
The unit is
whistling.
2. The duct pipe connections are not sealed or
connected properly.
The blower is
2. Defective LED bulb.
lights are not.
The hood is 1. The hood might be hanging to high from the
not venting out
properly.
2. The wind from the opened windows or opened
ventilation of the hood.
4. There are too many turns within the ducting.
5. Using the wrong size of ducting.
Filter is vibrating.
After hood has 1. Control board needs to be reset.
been installed
for a period of
time, it stopped
2. Defective control board.
What to do
power is ON.
connected properly.
board and control board are connected
properly.
4. Change the switch board or control board.
control board box
inside plug to see if pin is pushed inside the
plug too far. Reseat pin if needed.
3. Change the blower.
4. The blower will function properly after the
thermally protected system cool down.
5. Change the capacitor.
1. Tighten the blower in place.
2. Change the blower.
connections are sealed properly.
2. Change the LED bulb.
range.
2. Close all the windows and doors to eliminate
duct opening.
4. Limit number of turns and/or increase duct
size.
external blower.
2. Replace control board.
17