EUROM EK2000 Manuel D'utilisation page 10

cord cannot be stepped on and that no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
7. If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an
extension cord is unavoidable, then make sure it is an undamaged, approved extension cord with a minimum
diameter of 2.5 mm², suitable for a minimum permissible power of 2500 Watt. To prevent overheating, always
fully extend the cord!
8. To prevent the circuit overloading and fuses being blown, make sure no other appliances are connected to
the same socket or wired to the same electrical circuit as the heater.
9. Do not use the heater outdoors and do not use it in spaces smaller than 6 m².
10. A heater contains hot and/or glowing and sparking components. Do not, therefore, use in areas where fuels,
paint, flammable liquids and/or gasses etc. are stored.
11. Do not place the heater near, under or directly opposite a socket and do not place it near an open fire or
other heat source.
12. Do not use the heater near or directly opposite furniture, animals, curtains, paper, clothes, bedding or other
inflammable objects. Keep them at least 1 metre away from the heater!
13. Never cover a heater! The heater's air inlets and outlets should never be obstructed in any way, so as to
prevent the possibility of fire. Never use the heater to dry clothes and do not place anything on top of the
heater. Do not place it on soft surfaces such as beds or deep-pile carpets, as they can block openings.
14. Make sure that the air around the heater can circulate freely. Do not place the heater too close to walls or
large objects and do not place it under shelves, cupboards, and similar.
15. Prevent foreign objects from entering the heater via the venting or exhaust openings as this may lead to
electric shock, fire or damage.
16. Never leave the heater unattended when switched on. Always switch if off before removing the plug from the
socket. Always unplug the heater when not in use! Pull on the plug to remove from the socket, never pull on
the cord.
17. Always switch the heater off, unplug it and leave to cool down before:
- cleaning the heater
-
carrying out maintenance to the heater
-
touching or moving the heater. Use the handle for this!
18. This machine gets hot when it is in use. To prevent burns, do not let bare skin come into contact with hot
surfaces.
19. Do not use a timer or a similar product to automatically switch on the heater. Always perform safety checks
before using the heater!
20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or if there are signs of any other defect. Return the complete product to
the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories that have not been recommended or supplied by the
manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
EUROM EK heaters are 'real space' heaters, with a powerful fan which disseminates a great deal of air.
Cold air is sucked in at the back, heated, and then blown out as hot air. Because a relatively large quantity of air
is sucked in and blown out, the air expelled by the heater does not feel particularly hot. As a great deal of air is
heated and blown out, however, the entire space (not just the air around the heater!) is gradually warmed up.
Control panel EK2000:
10