Aqua Medic PERCULA 100 Mode D'emploi page 16

1. Product description
The aquarium system PERCULA 100 / 125 T5 consists of the following components:
PERCULA 100 / 125 T5
1 x aquarium 101,5 x 66,5 x 61 cm (Percula 100) resp.
•
126,5 x 66,5 x 61 (Percula 125), incl. frame
1 x cabinet
•
2 x sun cover 2 x 39 Watt cover incl. fans (Percula 100)
•
2 x sun cover 2 x 54 Watt cover incl. fans (Percula 125)
•
Open version: please refer to chapter 7.2.
•
1 x protein skimmer Blue 1000
•
1 x post skimming trickle filter with circulation pump (1,000 l/h)
•
2 x NanoProp 5000
•
Not included are a heater stick, a timer and a socket board.
The power of the required heater stick depends on the temperature of the aquarium environment.
If it is installed in an unheated room, it should have a power output of approx. 250 Watt. In heated
rooms, 100 - 150 Watt are sufficient for Percula 100 or 150 – 300 Watt for Percula 125.
2. Cabinet's assembly (refer to Fig. 1)
The assembly of the cabinet is done according to the following drawing (Fig. 1). The upper plate
hasn't to be screwed on. It has got four retaining blocks at the bottom so that it cannot
slip. This plate is already fixed at the bottom of the aquarium.
3. Set-up of the aquarium
The aquarium can be placed directly onto the cabinet. Beforehand, any dust on the plate should be
removed to avoid a bursting of the bottom glass caused through grains of sand or other coarse
particles.
The cable shaft of the aquarium must be positioned above the bore-hole of the cabinet.
Photo 1: Percula 100/125 T5
16