Promise Technology VessRAID 1740s Guide De Démarrage Rapide page 22

VessRAID 1740s, 1840s Quick Start Guide
8. Press the
The display shows the new IP address you set.
Making Automatic IP Settings
To make Management Port settings automatically:
1. Press the
2. Press the
If it says Link Status Down , reconnect to the network before preceding.
3. Press the
4. Press the
5. Press the
6. Press the
The display shows the new IP address set by the DHCP server.
This completes the Management Port setup.
Go to "Task 9: Creating Disk Arrays with WebPAM PROe" on page 23.
button to confirm.
or button until the display says Management Port .
button and the display says Link Status Up .
or button and the display says DHCP Disable.
button to make a change.
button to Enable.
button to confirm.
22