Promise Technology VessRAID 1740s Guide De Démarrage Rapide page 10

VessRAID 1740s, 1840s Quick Start Guide
Installing Your Disk Drives
1. Remove a disk drive carrier.
2. Carefully lay the disk drive into the drive carrier at the front, so that the screw
holes on the sides line up.
3. Insert the screws through the holes in the drive carrier and into the sides of
the disk drive.
• Install only the counter-sink screws supplied with the VessRAID.
• Install four screws per drive.
• Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the VessRAID chassis.
Repeat steps 1 through 3 until all of your disk drives are installed.
Figure 10.Disk drive mounted in a drive carrier
mounting screw
This completes disk drive installation. Go to "Task 5: Making Data and
Management Connections" on page 11.
mounting screw
VessRAID supports disk drive hot-swapping. To avoid hand
contact with an electrical hazard, do not remove more than one
drive carrier a time.
Caution
10
Disk drive