LaserLiner PowerCross-Laser 8 G Manuel D'utilisation page 20

Slope function up to max. 3°
4
Activation of the slope function deactivates the automatic sensor. Briefly press the auto/
man button on the remote control. The X-axis LEDs (15) light up. Motordriven adjustment
of the slope can now be carried out. Hold the plus or minus buttons down continuously
to adjust slope. The maximum slope range has been reached when the lasers flash. The
X/Y button (pressed briefly) is used to switch between axes. Refer to the illustrations
below.
For the slope function, laser lines are no longer aligned to the horizontal or
vertical plane. This is a specific peculiarity of adjusted laser lines. To reinstate
horizontal or vertical levelling, deactivate the slope function. To do so, switch
the device off and back on or keep the auto/man button pressed until the
laser lines move automatically.
The following operating instructions only apply when operating the device with
the remote control. The device is operated differently via the app.
Horizontal levelling adjustment up to a max. of 3° (X, Y axis)
5
Adjustment of the X axis up to a max. of 3°
The LEDs of the X-axis (15) light up in red.
Adjustment of the Y axis up to a max. of 3°
The LEDs of the Y-axis (16) light up in green.
20
EN
2x
2x
2x