Remote Control - LaserLiner PowerCross-Laser 8 G Manuel D'utilisation

Remote control

A
B
C
1 Use of lithium-ion rechargeable battery
Before using the laser for the first time, insert
the battery in the device and fully charge
(at least 6 hours). Connect the battery charger
to charge the battery. The LED of the battery
pack lights red while the battery is charging.
When the LED changes to green, charging is
complete. When the laser lines blink slowly,
the battery is low. In that case, recharge the
battery. The rechargeable battery can either
be charged when it is not inserted in the device
or when the device is in use.
– The battery may only be charged with the battery charger provided and
used only in this laser device. Any other use may cause injury or fire.
– Make sure there are no conductive objects in the vicinity of the
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
– Do not open the rechargeable battery. This could cause short-circuits.
Insert batteries into
the remote control
– Observing the correct polarity.
18
EN
A Horizontal laser lines
B Vertical laser lines
D
C auto/man function /
E
Incline X/Y axes
F
D Infrared signal emitter
E LED status indicator
G
F Hand receiver mode
H
G Move X/Y axes
H Move X/Y axes