Connect Cables And Terminals Of Wiring Board; Power Cord Connection; Connection Of Communication Line Of Idu And Odu - Gree GMV-ND100L/A-T Manuel D'utilisateur

5.1 Connect Cables and Terminals of Wiring Board

Connection of Wire and Patch Board Terminal
(1) The connection of wire (as shown in fig 5.1.1)
① Strip about 25mm insulation of the wire end by stripping and cutting tool.
② Remove the wiring screws on the terminal board.
③ Shape the tail of wire into ring by needle nose plier, and keep the gauge of ring in
accordance with screw.
④ Use the screwdriver for tightening the terminal.
(2) The connection of stranded wire (as shown in fig 5.1.2)
① Strip about 10mm insulation of the end of stranded wire by stripping and cutting tool.
② Loosen the wiring screws on terminal board.
③ Insert the wire into the ring tongue terminal and tighten by crimping tool.
④ Use the screwdriver for tightening the terminal.

5.2 Power Cord Connection

Note:
All indoor units must be unified of power supply so that they can be powered ON/OFF at the same time.
For units with single-phase power supply.
(1) Detach the electric box lid.
(2) Let the power cord pass through the wiring through-holes.
(3) Connect the power cord to terminal "L, N,
(4) Fix the power card with wiring clamp.

5.3 Connection of Communication Line of IDU and ODU

Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Fig 5.1.1
Multi VRF Floor Standing Indoor Unit
Fig 5.1.2
Fig 5.2
".
9