Preparation Of The Demineralization Cartridge; Demineralization Cartridge Preparation; Replacing The Demineralization Cartridge; Preparing The Hydro Cell - Boneco U700 Instructions D'utilisation

10
PREPAR ATION OF THE DEMINER ALIZ ATION CARTRIDGE
en

DEMINERALIZATION CARTRIDGE PREPARATION

The BONECO U700 is supplied with a A7531 deminer-
alization cartridge. The granules it contains has to soak
for 24 hours before being used in operation in order to be
most effective.
1. Unscrew the cartridge out of the appliance.
2. Place the cartridge with the cover into a typical house-
hold container filled with cold tap water and let it sit for
24 hours. The cartridge must be fully immersed in the
water.
3. Screw the cartridge back into the BONECO U700.
4. Continue with the instructions on page 11.

REPLACING THE DEMINERALIZATION CARTRIDGE

The cartridge has to be replaced every 2 to 3 months.
In cases of very hard water, it may have to be replaced
sooner. White dust around the appliance is a sure indica-
tion that the cartridge has run its course. You can obtain
replacements from your BONECO specialist dealer or our
online store at www.boneco.us
1. Soak the new cartridge for 24 hours as outlined on the
left.
2. Remove the cover from the old cartridge and dispose
of it with your regular household waste.
3. Screw the cover onto the new, freshly soaked cartridge.
4. Screw the cartridge back into the BONECO U700.

PREPARING THE HYDRO CELL

1. Remove the protective foil from the Hydro Cell.
2. Rinse the new Hydro Cell for 30 seconds under cold tap
water.
3. Put the new Hydro Cell into the water tank of the
BONECO U700.