Turn On/Off Seecode Vision - Seecode Vision HF920 Manuel D'utilisation

Mounting Seecode Vision on the vent
As shown in Figure 3, insert the vent mounting clip into the slot on the back of the Seecode Vision. Attach the vent
mounting clip to the vent using the clip. Adjust the fixing clip until it is firmly fixed to the vent.
Attach Seecode Vision in the car
Remove the paper on the bottom of the double-sided adhesive base and attach the base to a suitable flat surface in
the car. Insert the base into the slot on the back of Seecode Vision.
Adjustable
Double-sided adhesive base
Both the goose-neck bracket and the double-sided adhesive base are adjustable. You can adjust them to the correct
position before the mounting.
Note: For safety and to prevent any damage, please attach the accessory to the Seecode Vision before installing.
Too uninstall the Seecode Vision, remove the mounting accessory from its place of attachment first and then
remove the mounting accessory from the Seecode Vision.
2.3

Turn on/off Seecode Vision

Turn on Seecode Vision: Press and hold button
ready" and the word "Vision" appears on the screen.
Turn off Seecode Vision: Press and hold button
power off" and the screen is off.
Reset: The reset key is located on the side of Seecode Vision. When Seecode Vision is locked because due to any
mis-operation, you can recover it by pressing the reset key.
.
Adjustable
Mounting Seecode Vision on the windshield
Figure 2:
Mounting Seecode Vision on the vent
Figure 3:
Attach Seecode Vision in the car
Figure 4:
for at least 3 seconds until you hear the voice prompt "Vision
for at least 3 seconds until you hear the voice prompt "Vision
Capule
Locker
Unlockin
Vent clip
Fixing clip
Seecode Vision HF920
11