Using Seecode Vision; Battery Charging And Usage; Battery Charging; Battery Information - Seecode Vision HF920 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 96

Using Seecode Vision

2.
2.1

Battery Charging and Usage

2.1.1 Battery Charging

The Seecode Vision contains a rechargeable Li-Polymer battery. First time charging takes about 4 hours. Thereafter
recharging needs 2-3 hours. The charging procedure is as follows:
1)
Plug the connector of the charger into the USB port on the Seecode Vision.
Connect the car charger to the cigarette lighter to start charging.
2)
Icon indicator
is full and you can disconnect the charger.
You can also use the USB cable to charge the Seecode Vision on PC. Charging by using USB cable takes longer
than by using a car charger because the output power of the USB cable is smaller than that of the car charger.

2.1.2 Battery Information

Once fully charged, the battery will support continuous talk time up to 6 hours, standby time is up to 550 hours
without connection and 280 hours with connection established.
When the battery is low the Seecode Vision beeps once every two minutes and there is a message "Battery Low"
displayed on the screen. You can charge the battery as described above.
Note that, over-charging will shorten battery life. If a fully charged battery is left unused, it will lose power over
time. Extreme temperature (either too hot or too cold) will also affect the charging ability, capacity, and lifetime of
the battery.
2.2

Mounting Seecode Vision

The Seecode Vision is easily mounted inside the car by using one of the three accessories included. You can attach
the Seecode Vision to the windshield, the front vents or any flat surfaces in the car. With great portability and
flexibility the Seecode Vision can also be used outside of the car in other environments such as the office or at
home.
Note that, the microphone of the Seecode Vision must be in the direction of the user.
Mounting Seecode Vision on the windshield
Put the plastic cupule on the windshield and press down the locker to fix the mounting bracket firmly on the
windshield. Insert the other end of the bracket into the slot on the back of Seecode Vision; this connects the
Seecode Vision to the bracket. To remove the bracket from the windshield, press the unlocking button which is
located between the cupule and the locker.
.
will blink during the charging. When the icon changes to
Seecode Vision HF920
, it indicates that the battery
10

Publicité

Table des Matières
loading

Table des Matières