Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
LED
-
The blue LED lights up in the following conditions:
-
The blue LED blinks once every 20 minutes: the detector has lost the connection with the control unit.
-
The blue LED lights up for 30 seconds: the detector is being initialised and a fault is detected.
-
The blue LED blinks fast twice: the detector is connected correctly to the control unit following a learning procedure.
-
The blue LED lights up for two seconds during normal operation: The detector has detected motion and a fault was
detected.
-
The blue LED blinks: the detector is transmitting images to the control unit and a fault was detected.
-
The blue LED and the Flash LED blink once: the detector was reset.
Using the function button:
-
Press the button once to send a supervision signal.
-
To access Test mode: hold the function button pressed for five seconds.
-
To reset the detector: hold the button pressed for 10 seconds. Release the button when the illuminator and the blue LED
blink once.
JP1 Jumper
If the jumper is set to OFF, the detector has a sleep time of approximately 1 minute to save energy (default).
If the jumper is set to ON, the sleep time is disabled.
SLEEP TIME time that elapses between the transmission of a movement and the next transmission
Tamper
The tamper switch is activated when it is lifted and reset when it is compressed (against a wall or a surface).
Test mode
Test mode is used to control the detection coverage of the device not the wireless communication range with the control unit.
To access test mode, hold the function button pressed for a few seconds then release it to start the test mode that lasts for three
minutes.
The detector will start initialisation during the first 30 seconds. It is advisable not to generate alarms during this time.
Motion detection in front of the detector can be checked at the end of the initialisation period. The blue LED lights up for two
seconds after detection.
INDOOR INFRARED DETECTOR WITH CAMERA
QUICK GUIDE
IR600VC
1. Illuminator
2. IR sensor lens
3. Camera lens
4. Blue LED/Function button
5. Battery compartmentVano batteria
6. Jumper JP1
7. Tamper
Detection coverage
DS80TC1S-002A
Publicité
Table des Matières
