Table des Matières
Publicité
Slide open the lens barrier.
Faire coulisser le capot de protection de l'objectif.
Den Objektivschutzschieber öffnen.
Control panel
Écran de commande
LCD-Feld
Battery check
Contrôle des piles
Batterieprüfung
50
Number of storable pictures
Nombre de vues
enregistrables
Bildzählwerk (RestbiIder)
E
TURNING ON THE POWER
To turn on the power in the Record mode, just slide open the lens
barrier on the front of the camera. When it is turned on, it
automatically checks the SmartMedia card. If there is a problem
with the card, the camera emits a beep sound and displays the
following:
When there is no SmartMedia card in the camera / the card is
protected:
The Card error indicator on the control panel and the Green lamp
blink. (p. 250)
When the card needs to be formatted:
The Card error indicator on the control panel lights, and the
camera enters the Card format mode. (p. 222)
Note:
• Do not slide the lens barrier with a finger inside, as it may
cause damage to the camera.
• If you do not operate the camera for three minutes, the
camera will be set to the stand-by mode. After four hours in
the stand-by mode, the power turns off automatically. (Time
varies depending on the type of batteries used.)
• To turn on again, close and open the lens barrier.
• Set the date before taking pictures. (p. 214)
Publicité
Table des Matières
