Assembly - Husqvarna G462SL Manuel Du Propriétaire

1
REAR MOUNTING BRACKET
(See Figs. 1A, 1B & 1C)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear draw bar, simply hang the mounting
bracket, on the bolts. Discard included shoulder bolts and
disregard Fig. 1B.
SUPPORT

ASSEMBLY

If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
SELF TAPPING SHOULDER BOLTS (See Fig. 1B)
1. Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
SELF TAPPING
SHOULDER
BOLTS
TO REMOVE THE SUPPORT ASSEMBLY (See Fig. 1C)
1. Pull outward on the stop bracket enough to allow sup-
port assembly to be lifted up and away from drawbar.
ASSEMBLY
SHOULDER
BOLTS
Fig. 1A
Fig. 1B
PULL OUT ON STOP
BRACKET TO REMOVE
SUPPORT ASSEMBLY
Fig. 1C
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting cover assembly
to tractor.
1. Lift and rotate cover to align cover bracket with support
assembly.
2. Slide cover assembly down onto the support assembly.
COVER
ASSEMBLY
5
SUPPORT
ASSEMBLY