9.4.8
MENU 7. SOUND MODE
By activating this modality, the stove will emit a sound when the system detects a fault and goes into the alarm state. To
access to this menu you have to confirm with button nº 7 and then, choose "on" with buttons nº 1 and 2.
76"
22º C
LOAD
INITIAL
9.4.9
In case of the stove have no more fuel during the operation, to avoid an anomaly in the next ignition, it is possible to do a
fuel pre-load for maximum time of 90 seconds to load the screw-type conveyor when the stove is switched off and cold. To
MENU
start the load press button nº 2 and to stop it press button nº 3.
It is very important that the burner is totally clean when you start the stove. So, when the initial load is finished,
you must check the burner is clean of fuel to do correctly the ignition of the stove.
9.4.10
MENU 9. STOVE STATE
It shows up the current state of the stove and provides information about the devices connected. Therefore, the user can get a technical information. The
next screens are seen automatically.
29ºC
AMBIENT
1.0b
3.7
SPEED
STATE 5
OPERATIONAL
MENU
9.5
USER MODE
Below is a description of the control normal operation according to the available functions.
Before the ignition of the stove, the control shows the following screen: It is showed up the "off" state, the room temperature,
the established working power and the current hour.
14:24
21º C
P-2
IGNITION
9.5.1
In order to ignite the stove, press button no. 3 during a few seconds. The control will show the ignition state as follows:
The maximum length of the ignition phase is 20 minutes. After this time, if there is no visible flame, the stove will
automatically go into the alarm state and the control will show the message "Ignition Failure."
MENU
MENU 8. INITIAL LOAD
99ºC
2600
STATE 6
MENU
STOVE OR INSERT IGNITION
10"
SMOKE
80"
194 V RETE
SPEED EXTR.
00 A 19.7 V
OPERATIONAL
MENU
EN
ON
Menu 07
MODE
SOUND
MENU
TIME-OUT
TIME CLEANING
FAN
CHARACTERISTICS
14:24
21º C
P-2
OFF
MENU
43