Seasonal Stoppages; Maintenance Review - BOREAL RADIOFRÉQUENCE Série Instructions D'installation, D'utilisation Et D'entretien

EN
In addition, the Insert 7 model has a register on the right side that is accessed by sliding the insert on its guides.
In all cases, follow the next operations:
- Remove the register cover by loosening the screws.
- Clean the ashes deposited in the register, descaling the soot that has been deposited.
- Replace the parts and check the tightness of the register.
8.8

SEASONAL STOPPAGES

If the stove or insert is not going to be used for a long time it is advisable to keep the fuel tank empty, such as the
screw-type conveyor to avoid the fuel compacting. Clean the stove or insert and the smoke duct, removing the ashes and other residues and close the
stove door. It is recommended to clean the chimney at least once a year. Meanwhile, check the seals because if they are not in good condition (they do
not adjust to the door), they do not guarantee the proper operation of the stove or insert. For this reason, it would be necessary to change them. If there
is humidity in the place where the stove or insert is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral vaseline in
order to keep the appearance overtime.
8.9

MAINTENANCE REVIEW

It is also advisable to check and clean, at least once a year, the existent ashes registers on the stove.
Your stove has a preventive maintenance notice established after 1200 hours of operation, which will remember the
obligatory nature to clean the registers of your stove as soon as possible. These operations should be done exclusively by
an authorised technician.
This message is not an alarm, but a reminder or warning. It will therefore allow you to use your stove while this message is
displayed, but you must do an immediate cleaning of your stove.
Please, bear in mind that the stove could need to be cleaned before this 1200 hours established by default or even after
them. This depends on the quality of the fuel used, the smoke installation, and the proper regulation of the stove.
In the following table (also pasted on your stove in the fuel tank cover) you can check the frequency of the maintenance
tasks and who must do it.
CLEANING TASKS
Remove the burner from the chamber and clean the holes with the use of the poker provided. Remove the ash with a
vacuum-cleaner.
Hoover the ashes which are inside the burner place.
Empty the ash pan or vacuum the ash compartment when necessary.
Vacuum the bottom of the pellet tank when necessary.
Clean the internal of the combustion chamber descale in the walls with a correct vacuum cleaner.
Clean the smoke extractor fan, the whole combustion chamber, pellet tank, whole replacement of the seals and put again
silicone where necessary, smoke duct, reservoirs...
Check all the electronic components (electronic board, display...)
Check all the electrical components (resistance, smoke extractor engine, ...)
36
END
HOURS
MENU
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √