ECOVACS ROBOTICS WINBOT8 Mode D'emploi page 10

3. Operating the Robot
Loop one end of the Safety Tether to
1
End A on the Robot Power Cord and
tighten.
2
Connect End A and End B and tighten.
Loop the other end of the Safety
3
Tether around the Safety Pod's
channel and pull it tight.
If the length of the power cord restricts WINBOT 8's movement, a WINBOT Extension
*
Cord can be used. Disconnect End A and End B, and connect them with both ends of the
Extension Cord respectively and tighten.
Only one Extension Cord can be used when WINBOT 8 is cleaning an outside window.
*
8
EN