Charging Other Usb Devices; Status Of The Car Cradle Led - Tronic TKHQ 10 A1 Mode D'emploi

When charging is complete, disconnect the car/USB adapter 0 from
♦
the 12/24 V vehicle socket (cigarette lighter).
CAUTION
In vehicles in which the cigarette lighter also works with the ignition
►
switched off, the device must be disconnected from the cigarette lighter
after use. Otherwise, the vehicle battery may be discharged over a
long period of time, since the device also uses power when it is idle.

Charging other USB devices

CAUTION
If you use both USB sockets 7/9 to charge 2 devices at the same time,
►
the total current consumption may not exceed 5.4 A (= 5400 mA).
Otherwise, the car/USB adapter 0 could overload and be damaged.
You can also charge other devices that require a 5 V charging voltage
■
via the two USB sockets 7/9 on the car/USB adapter 0. To do this,
connect the charging cable of your device to one of the USB sockets on
the car/USB adapter 0.

Status of the car cradle LED

The LED 3 lights up as follows depending on the operating status:
LED
White LED lights up for 3 seconds
White LED lights up permanently
White LED off
White LED flashes
TKHQ 10 A1
Operating status
Car cradle has been connected
Mobile phone is being charged
Stand-by
Mobile phone is not compatible
GB │ IE │
15 ■